-436 Keysight E4980A/AL User’s Guide
Error Messages
Error Messages
-
GPIB devices in IEEE488.2
-440 Query UNTERMINATED error after indefinite response
A query that requests arbitrary data response (*IDN? and *OPT? queries) is
sent before normal queries in a program message (for example, FREQ?;*IDN?
is expected, but *IDN?;FREQ? is received).
-430 Query DEADLOCKED
Input buffer and output buffer are full; cannot continue.
-420 Query UNTERMINATED
Addressed to talk, incomplete program message received.
-410 Query INTERRUPTED
Query is followed by DAB or GET before the response is completed.
-400 Query error
Query is improper.
-350 Queue overflow
There is no room in the queue and an error occurred but was not recorded.
Suggestion:
Clear the error queue.
-250 Mass storage error
An error occurred while accessing the USB memory. A USB memory-related
error other than -257 error (File Name Error) occurred.
-230 Data corrupt or stale
The setting file or correction data to be read cannot be read out with the
current firmware version because the setting file or correction data is corrupt
or old.
-224 Illegal parameter value
The parameter value is not properly set. This error occurs, for example, when
the :FUNC:IMP command is used to specify an Impedance-parameter that
does not exist (as CPRS).
-223 Too many digits
The received numeric value is too long (exceeds 255 digits).
-223 Too much data
The block-, expression-, or character-string-type program data that are
received conform with the standard but exceed the amount that can be
processed under the condition of the memory or conditions specific to
memory-related devices. In this instrument, this error occurs when the number
of characters exceeds 254 in a character-string parameter.
To Next Page
Loading...
