Keysight E4980AL - Comparator:slimit; Comparator[:State]

332 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
E4980A/AL commands
10-
Parameter
Example of Use
viVPrintf(AgtE4980A/AL, "COMP:MODE SEQ" + vbLf, 0)
viVPrintf(AgtE4980A/AL, "FUNC:IMP RX" + vbLf, 0)
viVPrintf(AgtE4980A/AL, "COMP:SEQ:BIN -9.9e37,
100,110,120,130,140, 9.9e37,150" + vbLf, 0)
Equivalent key [Meas Setup] - LIMIT TABLE - Bin 1 LOW
[Meas Setup] - LIMIT TABLE - Bin 1 - 9 HIGH
:COMParator:SLIMit
Syntax :COMParator:SLIMit <Low>,<High>
:COMParator:SLIMit?
Description Sets the lower/upper limit values for the comparator function’s secondary
parameter.
Parameter
Equivalent key [Meas Setup] - LIMIT TABLE - 2nd LOW
[Meas Setup] - LIMIT TABLE - 2nd HIGH
:COMParator[:STATe]
Syntax :COMParator[:STATe] {ON|OFF|1|0}
:COMParator[:STATe]?
Description Enables the comparator function.
<Bin 1 Low>
Unit Depends on :FUNCtion:IMPedance[:TYPE]
<Bin n High>
Range of n 1 to 9
Unit Depends on :FUNCtion:IMPedance[:TYPE]
<Low>,<High>
Preset value -9.9E+37, 9.9E+37
Unit Depends on :FUNCtion:IMPedance[:TYPE]