Keysight E4980AL - Status:operation:enable; Status:operation[:Event]; System:beeper[:Immediate]; System:beeper:state

Keysight E4980A/AL Precision LCR Meter 369
SCPI Command Reference
E4980A/AL commands
10-
:STATus:OPERation:ENABle
Syntax :STATus:OPERation:ENABle <numeric>
:STATus:OPERation:ENABle?
Description Sets the value of the Operation Status Enable register.
Parameter
Equivalent key No equivalent key is available on the front panel.
:STATus:OPERation[:EVENt]
Syntax :STATus:OPERation[:EVENt]
Description Returns the value of the Operation Status Event register. (Query Only)
Equivalent key No equivalent key is available on the front panel.
:SYSTem:BEEPer[:IMMediate]
Syntax :SYSTem:BEEPer[:IMMediate]
Description Produces a beep sound. Even if the beep sound is disabled by the
:SYSTem:BEEPer:STATe command, a beep sound is still produced. (No Query)
Equivalent key No equivalent key is available on the front panel.
:SYSTem:BEEPer:STATe
Syntax :SYSTem:BEEPer:STATe {ON|OFF|1|0}
:SYSTem:BEEPer:STATe?
Description Enables a beep sound.
Parameter
<Numeric>
Range -32,768 to 32,767
Preset value 0
Description
ON or 1 Enables a beep sound