Keysight E4980AL - Format:exponent:digit; Frequency[:Cw]

Keysight E4980A/AL Precision LCR Meter 349
SCPI Command Reference
E4980A/AL commands
10-
Example of Use viVPrintf(AgtE4980A/AL, ":FORM REAL" + vbLf, 0)
Equivalent key No equivalent key is available on the front panel.
:FORMat:EXPonent:DIGit
Syntax :FORMat:EXPonet:DIGit {2|3}
:FORMat:EXPonet:DIGit?
Description Enables the three digit in exponent part. This is applied to the returned values
of :FETCh[:IMPedance][:FORMatted]?/:MEMory:READ?/*TRG. This setting is
remained even after preset/power off. This command is available at firmware
revision B.07.04 and above.
Parameter
Equivalent key No equivalent key is available on the front panel.
:FREQuency[:CW]
Syntax :FREQuency[:CW] <numeric>
:FREQuency[:CW]?
Description Sets the frequency for normal measurement.
Parameter
REAL Sets the transfer mode to Binary
Description
Description
2 The digit of exponent part is set at 2 (Factory default)
3 The digit of exponent part is set at 3
<Numeric>
Range
20 to 2M
1
Preset value 1k
Unit Hz
Resolution Depends on the setting frequency.
1. The range varys depending on the frequency option.