Keysight E4980AL - Page 384

384 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
Command list
10-
Format Long format enable :FORMat:ASCii:LONG
Data transfer order selection in
binary format
:FORMat:BORDer
Data transfer format selection :FORMat[:DATA]
Exponent part digit number
selection (ASCII format)
:FORMat:EXPonent:DIGit
Frequency Frequency setup :FREQuency[:CW]
Function DCR measurement auto range
function enable
:FUNCtion:DCResistance:RANGe:AUTO
DCR measurement range selection :FUNCtion:DCResistance:RANGe[:VALue]
Deviation measurement mode
selection
:FUNCtion:DEV[1-2]:MODE
Measurement execution for
reference values of the deviation
measurement
:FUNCtion:DEV[1-2]:REFerence:FILL
Reference value setup for deviation
measurement
:FUNCtion:DEV[1-2]:REFerence[:VALue]
Impedance measurement auto range
enable
:FUNCtion:IMPedance:RANGe:AUTO
Impedance measurement range
selection
:FUNCtion:IMPedance:RANGe[:VALue]
Measurement function selection :FUNCtion:IMPedance[:TYPE]
Dummy command (for 4284A
compatibility)
:FUNCtion:SMONitor:IAC[:STATe]
DC current level monitor enable :FUNCtion:SMONitor:IDC[:STATe]
Dummy command (for 4284A
compatibility)
:FUNCtion:SMONitor:VAC[:STATe]
DC voltage level monitor enable :FUNCtion:SMONitor:VDC[:STATe]
Hcopy Screen image output to the
controller
:HCOPy:SDUMp:DATA
Function Setting/execution item Command