404 Keysight E4980A/AL Precision LCR Meter
SCPI Command Reference
Command list
10-
BIN
CLEAR
TABLE
Clears the list sweep setup :LIST:CLE:ALL
COMP
OFF Turns OFF the comparator function :COMP:STAT OFF
ON Turns ON the comparator function :COMP:STAT ON
FUNC
SWAP
PARAM
Turns ON/OFF the swap parameter function :COMP:SWAP
High
CLEAR Clears the high limit values for the comparator function
CLEAR
LINE
Sets the lower/upper limit values of each BIN for the
comparator function tolerance mode
LOW
x(-1)
Sets the upper limit values for the comparator function
secondary parameter
:COMP:SLIM
LOW
CLEAR Clears the lower limit values for the comparator function
CLEAR
LINE
Sets the lower/upper limit values of each BIN for the
comparator function tolerance mode
HIGH
x(-1)
Sets the lower limit values for the comparator function
secondary parameter
:COMP:SLIM
MODE
% Selects the limit mode of the comparator function :COMP:MODE PTOL
ABS Selects the limit mode of the comparator function :COMP:MODE ATOL
SEQ Selects the limit mode of the comparator function :COMP:MODE SEQ
NOM Sets the nominal value for the tolerance mode of the
comparator function
:COMP:TOL:NOM
LIST SETUP
FREQ[Hz]
FREQ
[Hz]
Clears the previous list sweep table, sets frequency
sweep as the list sweep parameter, and sets frequency
points for the frequency list sweep
:LIST:FREQ
Key Operation Function SCPI Command
To Next Page
Loading...
