Keysight E4980A/AL User’s Guide -433
Manual Changes
Manual Changes
-
For “Status” of the firmware revision A.02.00 or lower, which displays the LAN
connection status, refer to the following table.
The firmware revision A.01.0x does not support the following SCPI command.
Please delete the descriptions about this command from this manual.
— “:SYSTem:COMMunicate:LAN[:SELF]:CONFigure” on page 372
The firmware revision A.02.00 or later does not support the following SCPI
commands.
— “:SYSTem:COMMunicate:LAN[:SELF]:AIP[:STATe]” on page 371
— “:SYSTem:COMMunicate:LAN[:SELF]:DHCP[:STATe]” on page 373
Status Description
OK LAN connection is OK
DISCONNECTED Disconnected from the LAN
INITIALIZING LAN connection is being initialized
FAILED LAN connection has failed.
To Next Page
Loading...
