344
g: Resonance, h: Wet/Dry
The peak shape of the positive and negative Feedback value is
different. The harmonics will be emphasized when the effect
sound is mixed with the dry sound, if you set a positive value for
both “Resonance” and “Wet/Dry”, and if you set a negative value
for both “Resonance” and “Wet/Dry”.
g: High Damp [%]
This parameter sets the amount of damping of the resonance in
the high range. Increasing the value will cut high-range harmon-
ics.
024: Random Phaser
This is a stereo phaser. The effect uses a step-shape waveform
and random LFO for modulation, creating a unique phasing
effect.
025: Envelope Phaser
This stereo phaser uses an envelope generator for modulation.
You will obtain the same pattern of phasing each time you play.
You can also control the Phaser directly using the modulation
source.
a
LFO Waveform Step-Tri, Step-Sin, Random
Selects LFO Waveform
☞ Fx:010
b
LFO Phase [degree] –180...+180
Sets the LFO phase difference between the left and right
☞ Fx:010
c
LFO Frequency [Hz] 0.02...20.00Hz
Sets the LFO speed
☞ Fx:010,
Src Off...Tempo
Selects the modulation source commonly used for LFO speed and step
speed
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
d
LFO Step Freq (Frequency) [Hz] 0.05...50.00Hz
Sets the LFO step speed
☞ Fx:010,
Amt –50.00...+50.00Hz
Sets the modulation amount of LFO step speed
e
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using the
tempo and notes
☞ Fx:009,
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
☞009, 010
Base Note
Selects the type of notes that specify the LFO speed ☞ Fx:009
Times x1...x16
Sets the number of notes that specify the LFO speed
☞ Fx:009
f
Step Base Note
Selects the type of notes to specify the LFO step speed
☞ Fx:010,
Times x1...x32
Sets the number of notes to specify the LFO step speed
☞ Fx:010
g
Manual
Sets the frequency to which the effect is applied
0...100
h
Depth
Sets the depth of LFO modulation
0...100
i
Resonance
Sets the resonance amount
–100...+100
☞ Fx:023
High Damp [%] 0...100%
Sets the resonance damping amount in the high range
☞ Fx:023
LFO: Step-Tri/Random
Left
Right
Resonance
LFO Phase
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Phaser
Phaser
j
Wet/Dry –Wet...–1:99, Dry, 1:99...Wet
Table , “Sets the balance between the effect and dry sounds,” on page 330
☞ Fx:010, 023,
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 330
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 330
–100...+100
a
L Manu Bottom (L Manual Bottom) 0...100
Sets the lower limit of the frequency range for the effect on the left channel
☞ Fx:009
L Manu Top (L Manual Top) 0...100
Sets the upper limit of the frequency range for the effect on the left channel
☞ Fx:009
b
R Manu Bottom (R Manual Bottom) 0...100
Sets the lower limit of the frequency range for the effect on the right channel
☞ Fx:009
R Manu Top (R Manual Top) 0...100
Sets the upper limit of the frequency range for the effect on the right channel
☞ Fx:009
c
Sweep Mode EG, D-mod
Determines whether the flanger is controlled by the envelope generator or
by the modulation source
☞ Fx:022,
Src Off...Tempo
Selects the modulation source that triggers the EG (when EG is selected for
Sweep Mode), or modulation source that causes the flanger to sweep
(when D-mod is selected for Sweep Mode)
d
EG Attack
Sets the EG attack speed
1...100
☞ Fx:022
EG Decay
Sets the EG decay speed
1...100
☞ Fx:022
e
Resonance
Sets the resonance amount
–100...+100
☞ Fx:023
f
High Damp [%] 0...100%
Sets the resonance damping amount in the high range
☞ Fx:023
g
Wet/Dry –Wet...–1:99, Dry, 1:99...Wet
Table , “Sets the balance between the effect and dry sounds,” on page 330
☞ Fx:010, 023,
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 330
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 330
–100...+100
EG Attack/Decay
EG
D-mod
Sweep Mode
D
-mod
Phaser
Phaser
Left
Right
Resonance
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
To Next Page
Loading...
Need help?
General
