95
The logical port for the settings.
VLAN ID :
The VLAN id for the settings.
IP Address :
Allowed Source IP address.
MAC address :
Allowed Source MAC address.
Adding new entry :
Click to add a new entry to the Static IP Source Guard table. Specify the Port, VLAN
ID, IP address, and IP Mask for the new entry. Click "Save".
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-5.2.5 ARP Inspection
The section describes to configure the ARP Inspection parameters of the switch. You
could use the ARP Inspection configure to manage the ARP table.
2-5.2.5.1 Port Configuration
This section describes how to configure ARP Inspection setting including：
Mode (Enabled and Disabled)
Port (Enabled and Disabled)
Web Interface
To configure an ARP Inspection Configuration in the web interface:
1. Select “Enabled” in the Mode of ARP Inspection Configuration.
2. Select “Enabled” of the specific port in the Mode of Port Mode Configuration.
3. Click Apply.
To Next Page
Loading...
