97
Enabled: Enable check VLAN operation.
Disabled: Disable check VLAN operation.
Only the Global Mode and Port Mode on a given port are enabled, and the setting
of "Check VLAN" is disabled, the log type of ARP Inspection will refer to the port
setting. There are four log types and possible types are:
None: Log nothing.
Deny: Log denied entries.
Permit: Log permitted entries.
ALL: Log all entries.
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-5.2.5.2 VLAN Configuration
Each page shows up to 9999 entries from the VLAN table, default being 20, selected
through the "entries per page" input field. When first visited, the web page will show
the first 20 entries from the beginning of the VLAN Table. The first displayed will be the
one with the lowest VLAN ID found in the VLAN Table.
The "VLAN" input fields allow the user to select the starting point in the VLAN Table.
Clicking the button will update the displayed table starting from that or the closest
next VLAN Table match. The will use the next entry of the currently displayed VLAN
entry as a basis for the next lookup. When the end is reached the warning message is
shown in the displayed table. Use the button to start over.
Web Interface
To configure a VLAN Mode Configuration in the web interface:
1. Click “Add new entry”.
2. Specify the VLAN ID, Log Type
3. Click Apply.
Figure 2-5.2.5.2: The VLAN Mode Configuration
To Next Page
Loading...
