100
2-5.2.5.3 Static Table
The section describes to configure the Static ARP Inspection Table parameters of the
switch. You could use the Static ARP Inspection Table configure to manage the ARP
entries.
Web Interface
To configure a Static ARP Inspection Table Configuration in the web interface:
1. Click Configuration, Security, Network, ARP Inspection and Static Table.
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click Apply.
Figure 2-5.2.5.3: The Static ARP Inspection Table
Parameter description:
Delete :
Check to delete the entry. It will be deleted during the next save.
To Next Page
Loading...
