101
Port :
The logical port for the settings.
VLAN ID :
The vlan id for the settings.
MAC Address :
Allowed Source MAC address in ARP request packets.
IP Address :
Allowed Source IP address in ARP request packets.
Adding new entry :
Click to add a new entry to the Static ARP Inspection table. Specify the Port, VLAN
ID, MAC address, and IP address for the new entry. Click "Save".
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-5.2.5.4 Dynamic Table
Entries in the Dynamic ARP Inspection Table are shown on this page. The Dynamic ARP
Inspection Table contains up to 1024 entries, and is sorted first by port, then by VLAN
ID, then by MAC address, and then by IP address.
Navigating the ARP Inspection Table
Each page shows up to 99 entries from the Dynamic ARP Inspection table, default
being 20, selected through the "entries per page" input field. When first visited, the
web page will show the first 20 entries from the beginning of the Dynamic ARP
Inspection Table.
The "Start from port address", "VLAN", "MAC address" and "IP address" input fields
allow the user to select the starting point in the Dynamic ARP Inspection Table.
Clicking the button will update the displayed table starting from that or the closest
next Dynamic ARP Inspection Table match. In addition, the two input fields will - upon
a button click - assume the value of the first displayed entry, allowing for continuous
To Next Page
Loading...
