152
SSM (Source-Specific Multicast) Range allows the SSM-aware hosts and routers run
the SSM service model for the groups in the address (Using IPv6 Address) range.
Leave Proxy Enabled :
Enable MLD Leave Proxy. This feature can be used to avoid forwarding unnecessary
leave messages to the router side.
Proxy Enabled :
Enable MLD Proxy. This feature can be used to avoid forwarding unnecessary join
and leave messages to the router side.
Fast Leave :
To evoke to enable the fast leave on the port.
Router Port :
Specify which ports act as router ports. A router port is a port on the Ethernet
switch that leads towards the Layer 3 multicast device or MLD querier. If an
aggregation member port is selected as a router port, the whole aggregation will
act as a router port.
Throttling :
Enable to limit the number of multicast groups to which a switch port can belong.
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
2-12.2.2 VLAN Configuration
When MLD snooping is enabled on a VLAN, the switch acts to minimize unnecessary
multicast traffic. If the switch receives multicast traffic destined for a given multicast
address, it forwards that traffic only to ports on the VLAN that have MLD hosts for that
address. It drops that traffic for ports on the VLAN that have no MLD hosts
The will use the last entry of the currently displayed entry as a basis for the next
lookup. When the end is reached the text "No more entries" is shown in the displayed
table. Use the button to start over.
To Next Page
Loading...
