155
tenths of seconds; default query response interval is 100 in tenths of seconds (10
seconds).
LLQI (LMQI for IGMP) :
Last Member Query Interval. The Last Member Query Time is the time value
represented by the Last Member Query Interval, multiplied by the Last Member
Query Count. The allowed range is 0 to 31744 in tenths of seconds; default last
member query interval is 10 in tenths of seconds (1 second).
URI :
Unsolicited Report Interval. The Unsolicited Report Interval is the time between
repetitions of a host's initial report of membership in a group. The allowed range is
0 to 31744 seconds, default unsolicited report interval is 1 second. .
Buttons :
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
Upper right icon (Refresh, |<<, >>) :
You can click them Refreshes the displayed table starting from the "VLAN" input
fields. Or click “|<<” to update the table starting from the first entry in the VLAN
table, i.e. the entry with the lowest VLAN ID. Others click “>> “ to update the table,
starting with the entry after the last entry currently displayed.
2-12.2.3 Port Group Filtering
The section describes that you could to set the Port Group Filtering in the MLD
Snooping function. On the UI that you could add new filtering group and safety policy.
Web Interface
To configure the MLD Snooping Port Group Configuration in the web interface:
1. Click Configuration, IPMC, MLD Snooping, Port Group Filtering Configuration
2. Click the Add new Filtering Group
3. Specify the Filtering Groups with entries per page.
To Next Page
Loading...
