154
Querier Address :
Define the IPv4 address as source address used in IP header for IGMP Querier
election.
When the Querier address is not set, system uses IPv4 management address of the
IP interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first available IPv4
management address.
Otherwise, system uses a pre-defined value. By default, this value will be 192.0.2.1.
Compatibility :
Compatibility is maintained by hosts and routers taking appropriate actions
depending on the versions of IGMP operating on hosts and routers within a
network. The allowed selection is IGMP-Auto, Forced IGMPv1, Forced IGMPv2,
Forced IGMPv3, default compatibility value is IGMP-Auto.
PRI :
Priority of Interface.
It indicates the IGMP control frame priority level generated by the system. These
values can be used to prioritize different classes of traffic.
The allowed range is 0 (best effort) to 7 (highest), default interface priority value is
0.
Rv :
Robustness Variable. The Robustness Variable allows tuning for the expected packet
loss on a network. The allowed range is 1 to 255; default robustness variable value is
2.
QI :
Query Interval. The Query Interval is the interval between General Queries sent by
the Querier. The allowed range is 1 to 31744 seconds; default query interval is 125
seconds.
QRI :
Query Response Interval. The Max Response Time used to calculate the Max Resp
Code inserted into the periodic General Queries. The allowed range is 0 to 31744 in
To Next Page
Loading...
