82
Clicking these buttons will not cause settings changed on the page to take effect.
Re-authenticate: Schedules a re-authentication whenever the quiet-period of the
port runs out (EAPOL-based authentication). For MAC-based authentication,
re-authentication will be attempted immediately.
The button only has effect for successfully authenticated clients on the port and will
not cause the clients to get temporarily unauthorized.
Reinitialize: Forces a re-initialization of the clients on the port and thereby a
re-authentication immediately. The clients will transfer to the unauthorized state
while the re-authentication is in progress.
Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
Upper right icon (Refresh):
You can click them for refresh the NAS Configuration by manual.
2-5.2.3 ACL
The IGP-1271 Series switch access control list (ACL) is probably the most commonly
used object in the IOS. It is used for packet filtering but also for selecting types of
traffic to be analyzed, forwarded, or influenced in some way. The ACLs are divided into
Ether Types. IPv4, ARP protocol, MAC and VLAN parameters etc. Here we will just go
over the standard and extended access lists for TCP/IP. As you create ACEs for ingress
classification, you can assign a policy for each port, the policy number is 1-8, and
however, each policy can be applied to any port. This makes it very easy to determine
what type of ACL policy you will be working with.
2-5.2.3.1 Ports
The section describes how to configure the ACL parameters (ACE) of the each switch
port. These parameters will affect frames received on a port unless the frame matches
a specific ACE
To Next Page
Loading...
