LIP-7004N User Guide
ï‚· Dial the desired System Speed Dial bin number (200-999 for iPECS-
100 or 2000-4999 for iPECS-300 or 600, 2000-2999 for iPECS-
MG100, 2000-4999 for iPECS-MG300).
3.3.4 Using and Entering Station Speed Dial Numbers
Each station in the iPECS-100 is allocated memory for 20 Station
Speed Dial numbers (bins 00-19) each up to 48 digits. The iPECS-300
& 600 each support 100 Station Speed Dial numbers (bins (000-099).
The iPECS-MG 100 & 300 each support 50 Station Speed Dial
numbers (bins (00-49). These numbers are entered at the user’s station
and may include several ‘special’ instructions. Special instructions and
the corresponding button are:
‘#’ – Pause, system will momentarily stop dialing.
Flash as 1st digit – activate dial tone detect.
Flash not as 1st digit – the system will generate a flash on the CO line.
Call Back a
s 1st digit – Send digits as ISDN Keypad Facility message.
‘*’ as 1st digit - Display
Security, the stored number will not be
displayed when used.
‘*’ not as 1st digit, - Dial Pulse to Tone Switchover, the system will
switch from pulse to DTMF dialing.
When entering a Speed Dial, a 16-character name, may be associated
with the number for Dial by Name which is only available to display
phones. Characters are entered with two keystrokes as in the chart
below.
Q – 11
Z – 12
. – 13
1 – 10
A - 21
B - 22
C - 23
2 - 20
D - 31
E - 32
F - 33
3 - 30
G – 41
H - 42
I - 43
4 - 40
J - 51
K - 52
L - 53
5 - 50
M - 61
N - 62
O - 63
6 - 60
P - 71
R - 72
S - 73
Q - 7*
7 - 70
T - 81
U - 82
V - 83
8 - 80
W - 91
X - 92
Y - 93
Z - 9#
9 - 90
*1 -
Blank
*2 - :
*3 - ,
0-00 #
Character Entry
19
To Next Page
Loading...
Need help?
General
