LIP-8040L User Guide
13
Additionally, you may switch between the handset and
Speakerphone during a call. By keeping the handset
Off-hook, the Group Listen feature is activated, which
provides incoming audio over the speaker with outgoing
audio from the handset. This permits a local ‘group’ to
listen to both sides of the conversation without
interfering with the conversation.
While in a conversation using the Speakerphone, Mute
the microphone using the M
UTE button. When Mute is
active, the MUTE button LED will be illuminated. To turn
off Mute, press the MUTE button again.
With Auto Speaker Select, activating or accessing a
feature by pressing its button will activate the
Speakerphone automatically.
When using a Headset, the
SPEAKER button controls the
ON/OFF-hook state for the phone.
2.4 Using a Bluetooth Wireless Headset
The iPECS LIP-8040L may be equipped with a
Bluetooth Unit (BTU) allowing you to use a wireless
headset that supports Bluetooth version 2.0. Using a
headset permits you to move freely around the phone
(within approximately 10 meters) and maintain a
conversation. Before using the headset, the headset
must be “paired” with the BTU, and then the headset
must be enabled for use. Operation of the iPECS LIP-
8040L with the headset is the same as with the
To use the Speakerphone to answer or place a call:
Press
SPEAKER, the phone goes off-hook and sends
audio to the speaker and the microphone.
To control the volume of the Speakerphone or handset:
Press the
VOL▲ VOL▼ button.
To Mute the microphone:
Select the M
UTE button.
To turn off Mute (turn the microphone ON):
Press the M
UTE button.
To activate Group Listen while on an active handset call:
Press the SPEAKER button.