To Next Page

To Previous Page

LIP-8040L User Guide

NOTE—When the BTU is used for a call, the Speaker

button LED will illuminate and the speaker mode

cannot be used. If the phone handset is taken off-

hook while in BT mode, the voice path will directly

be connected to the handset; press the Speaker

button to activate the BTU headset.

2.5 Using a Serial DSS

he LIP-8012DSS, LIP-8012LSS, and LIP-8048DSS

can be connected with the LIP-8040L using the RS-232

cable. Be sure to verify the serial DSS and LSS

capacities with the iPECS System to ensure usability

(refer to iPECS Manual). The following graphics show

the front and rear view of each.

NOTE—A Linked Pair slave station cannot use a

serial DSS.

To unpair the BTU headset:

 Set the Bluetooth headset to pairing mode,

 Press the TRANS/PGM button,

 Dial *8(iPECS-LIK)/63(iPECS-MG),

 Dial 2 (disable),

 Press the OK

soft button.

To check BTU paired information:

 Press the

TRANS/PGM button,

 Dial *8(iPECS-LIK)/63(iPECS-MG),

 Dial 3,

 Press the OK

soft button.

To use the BTU headset:

 Press the S

PEAKER button,

 Press the Call Start button on the BTU headset,

 Place call as you normally would.

To answer a call with the BTU headset:

 When an incoming call is received, ringing will be

present at the Station and the BT headset,

 Press the BT Call Start button, or press the Speaker

button,

 Lift the handset.

LG-Ericsson LDP-7008 D User Manual

Questions and Answers: