LIP-8012D & LIP-8024D User Guide
57
8.6 Wake-Up Alarm
iPECS supports an Alarm clock for each station in the
system. The alarm clock can be set to repeat daily or
as a one-time alarm.
When responding to the alarm by lifting the handset,
BGM will be provided.
8.7 Alarm/Door Bell
The system can monitor external Alarm or Door Bell
contacts:
Alarm Monitor—should the external contact activate, a
unique Alarm Ring signal and LCD display may be
received. To restart the monitor circuit, the external
contacts must be deactivated and the Alarm Ring signal
terminated.
Door Bell—a unique Door Bell Ring (single tone burst)
may be received each time the external contact is
activated. A system contact also can be assigned to act
as a Door Open contact.
NOTE—Contacts 3 & 4 are only available in the
iPECS-300 & 600. Contacts 1 is available in the
iPECS -MG.
To terminate the Alarm signal:
ï‚· Dial 565 (Alarm Stop code).
To activate the Door Open contacts:
ï‚· Lift the handset,
ï‚· Dial Door Open code, #* and contact number 1-4.
To set the Wake Up Alarm clock:
ï‚· Press
TRANS/PGM,
ï‚· Dial 41(iPECS-LIK)/13(iPECS-MG) (Alarm Clock code),
ï‚· Dial 2-digit hour and minute for alerting,
ï‚· For a daily (repeating alarm), press #,
ï‚· Press
HOLD/SAVE.
To erase Wake-Up:
ï‚· Press
TRANS/PGM,
ï‚· Dial 42(iPECS-LIK)/14(iPECS-MG) (Alarm Clock delete
code),
ï‚· Press
HOLD/SAVE.