LIP-7008D User Guide
16
4.2 External Calls
4.2.1 Placing external CO/VoIP calls
External calls are placed on CO/IP lines. These ‘lines’ are accessed
either by a button on the iPECS Phone assigned as a CO/IP line or by
dial codes. The CO/IP lines are grouped for different types of calls, local,
long distance, etc. Using the CO/IP line group code, you will be able to
access any line from the group. A Flex button on the iPECS Phone
assigned as a LOOP button lets you access a line from a group. Dial
codes for access to CO/IP lines are:
Individual CO/IP line access
Individual CO/IP line Access Code Line No System
01-42 iPECS-50 & 100
001-200 iPECS-300
001-400 iPECS-600
88
001-600 iPECS-1200
01-80 iPECS-MG100 88
001-240 iPECS-MG300
CO/IP Group access—
CO/IP Group Access Code System
801 – 820 iPECS-50 & 100
801 – 872 iPECS-300 & 600
8001 – 8200 iPECS-1200
801 – 824 iPECS-MG100
801 - 872 iPECS-MG300
Any CO/IP Line access—
9
When dialing on a CO line, which uses pulse style signals, you may
activate Dial Pulse to Tone Switchover changing to DTMF style dialing
for banking services, etc.
When placing an IP call, an IP address is dialed using the ‘*’ key in place
of the dot.
If Least Cost Routing is set-up, the number you dial will be analyzed
and the system will place the call on the least expensive route.
You may be assigned Dialing and/or CO/IP Line Access Restrictions,
in which case you will receive error tone if you attempt to dial or access a
restricted number/CO/IP line. CO/IP line and Station Class Of Service
(COS), which establish dialing restrictions, may vary during Day and
Night operation (Day/Night COS).
To Next Page
Loading...
Need help?
General
