LIP-8050V User Guide
36
3. LCD, SPEAKERPHONE & RELATED FEATURES
3.1 Using the Speakerphone
Activate the iPECS Speakerphone at any time (except for
Paging) in place of lifting the handset to receive or place calls.
Additionally, you may switch between the handset and
Speakerphone during a call. By keeping the handset Off-hook,
the Group Listen feature is activated, which provides incoming
audio over the speaker with outgoing audio from the handset.
This permits a local ‘group’ to listen to both sides of the
conversation without interfering with the conversation.
While in a conversation using the Speakerphone, Mute the
microphone using the MUTE
button. When Mute is active, the
display selection changes to SPEAK. To turn the microphone on,
press the SPEAK
soft button.
With Auto Speaker Select, activating or accessing a feature by
pressing its button will activate the Speakerphone automatically.
When using a Headset, the
SPEAKER
button controls the
ON/OFF-hook state for the phone.
3.2 Using a Serial DSS
The LIP-8012DSS, LIP-8012LSS, and LIP-8048DSS can be
connected with the LIP-8050V using the RS-232 cable. Be sure
to verify the serial DSS and LSS capacities with the iPECS
System to ensure usability (refer to iPECS Manual). The
following graphics show the front and rear view of each.
NOTE—A Linked Pair slave station cannot use a serial DSS
(iPECS-Lik).
To use the Speakerphone to answer or place a call:
ï‚· Press
SPEAKER
, the phone goes off-hook and sends audio to
the speaker and the microphone.
To control the volume of the Speakerphone or handset:
ï‚· Press the
VOLâ–²
VOLâ–¼
button.
3. LCD, Speakerphone
& Related Features
To Next Page
Loading...
Need help?
General
