To Next Page

To Previous Page

LIP-7024LD User Guide

9.4 Wake-Up Alarm

iPECS supports an Alarm clock for each station in the system. The

alarm clock can be set to repeat daily or as a one-time alarm.

When responding to the alarm by lifting the handset, BGM will be

provided.

OPERATION

To set the Wake Up Alarm clock:

 Press TRANS/PGM,

 Dial the Station User Program code 41(iPECS-Lik)/13(iPECS-MG),

 Dial 2-digit hour and minute for alerting,

 For a daily (repeating alarm), dial #,

 Press HOLD/SAVE .

To erase Wake-Up:

 Press TRANS/PGM,

 Dial the Station User Program code 42 (iPECS-Lik)/14(iPECS-MG),

 Press HOLD/SAVE .

9.5 Alarm/Door Bell

The system can monitor external Alarm or Door Bell contacts:

Alarm Monitor—should the external contact activate, a unique Alarm

Ring signal and LCD display may be received. To restart the monitor

circuit, the external contacts must be deactivated and the Alarm Ring

signal terminated.

Door Bell—a unique Door Bell Ring (single tone burst) may be received

each time the external contact is activated. A system contact also can

be assigned to act as a Door Open contact.

OPERATION

To terminate the Alarm signal:

 Dial 565.

To activate the Door Open contacts:

 Lift the handset,

 Dial Door Open code, #* and contact number 1-4.

NOTE—Contacts 3 & 4 are only available in the iPECS -300 & 600.

—Contacts 1 is available in the iPECS -MG.

LG-Ericsson LDP-7008 D User Manual

Questions and Answers: