LIP-8004D User Guide
Receiving Calls
2. Receiving Calls
2.1 Answering a Call While Idle
There are 3 basic types of incoming calls;
internal/external ringing calls, Intercom Voice
Announce calls, and Hold recalls.
Your phone may be assigned Ringing Line
Preference; in this case, calls that ring are answered
by lifting the handset. Otherwise, you must press the
flashing Flex button.
External calls to an iPECS Phone will appear under the
CO/IP line button or a LOOP button. External calls are
from CO lines or VoIP channels that are programmed to
ring at your phone. For external calls, Delay Ring may
be assigned allowing others to answer the call before
the call rings at your phone.
Calls can be forwarded in some manner from another
user; if providing call coverage for other users, you may
also receive Station Call Coverage calls.
Calls placed on Hold, including Transfers, parked calls,
etc., will Recall if left on hold for too long.
ICM Voice Announce calls are answered based on the
ICM Signaling mode at the receiving phone; in Hands-
Free (HF) mode, after the splash tone and
announcement, speak normally into the microphone. In
the Privacy (PV) mode, lift the handset to respond. The
ICM Signaling mode can be assigned in Station
Progra
mming.
To answer a call ringing at your phone:
ï‚· Lift the handset and, then press the flashing Flex button (as
needed), the call will be connected.
To respond to an Intercom Voice Announce call:
ï‚· Lift the handset to respond.
2.2 Responding to a Call While Busy
While you are busy on another call, you may receive a
Muted Ring, Camp-On tones, or Voice-Over
announcements. Muted Ring is provided over the
speaker of your Phone indicating a Call Waiting. You
also may receive Camp On tones, a burst of tones on
5
To Next Page
Loading...
Need help?
General
