LIP-7008D User Guide
4
3. Receiving Calls
3.1 Answering a Call While Idle
There are 3 basic types of incoming calls; Internal/External Ringing
calls, Intercom Voice Announce calls, and Hold recalls.
Your ph
one may be assigned a Ringing Line Preference to determine
the order incoming calls are answered by lifting the handset. Otherwise,
you must press the flashing Flex button.
External calls to an iPECS Phone will appear under the CO/IP line button
or a LOOP button. External calls are from CO lines or VoIP channels
that are programmed to ring at your phone. For external calls, Delay
Ring may be assigned allowing others to answer the call before the call
rings at your phone.
Calls can be forwarded in some manner from another user; if providing
call coverage for other users, you may also receive Station Call
Coverage calls.
Calls placed on Hold, including Transfers, parked calls, etc., will Recall if
left on hold for too long.
ICM Voice Announce calls are answered based on the ICM Signaling
mode at the receiving phone; in Hands-Free (HF) mode, after the splash
tone and announcement, speak normally into the microphone. In the
Privacy (PV) mode, lift the handset to respond. The ICM Signaling
mode can be assigned in Station Programming.
The L
CD will display the calling number or, if available, the name of the
Station or CO/VoIP line, CO Line Name Display.
OPERATION
To answer a call ringing at your phone:
ï‚· Lift the handset and, then press the flashing Flex button (as needed),
the call will be connected.
To respond to an Intercom Voice Announce call:
ï‚· In HF mode signaling, simply speak as normal into the microphone
or,
ï‚· In Privacy mode signaling, lift the handset to respond.
3.2 Responding to a Call a While Busy
While you are busy on another call, you may receive Muted Ring, Camp-
On tones, or Voice-Over announcements. Muted Ring is provided over
the speaker of your Phone indicating a Call Waiting. You also may
To Next Page
Loading...
Need help?
General
