LIP-8004D User Guide
In iPECS-MG
To s
et-up a Conference Room:
ï‚· Press the
TRANS/PGM button,
ï‚·
Dial 54 to create a Conference Room,
ï‚· Dial the desired Conference Room number (571-579),
ï‚· If desired enter a password for the Conference Room (up to 12
digits),
ï‚· Press
HOLD/SAVE to establish the Room.
To join a Conference Room:
ï‚·
Lift the handset,
ï‚· Dial 571-579 (Conference Room entry code),
ï‚· Dial the Conference Room password.
To delete a Conference Room:
ï‚· Press the TRANS/PGM button,
ï‚·
Dial 55 (Conference Room delete code),
ï‚· Dial the Conference Room number (571-579),
ï‚· Dial the Conference Room password,
ï‚· Press
HOLD/SAVE to delete the Conference Room.
4.5 Call Park: Placing a call on hold to Page
A user may transfer an active CO/IP call to a special
holding location (Park Orbit), which can be accessed
easily from any station in the system. Typically, this
feature is used with Paging to notify the desired User of
Call Park.
Parked cal
ls are subject to Hold Recall after the Call
Park timer.
In iPECS-LIK
To park an active external call:
ï‚· Press T
RANS/PGM,
ï‚·
Dial the Park Orbit code (601-610 for iPECS-100, or 601-619
for iPECS-300 & 600),
ï‚· Return to idle.
To retrieve a parked call:
ï‚· Lift the handset,
ï‚· Dial the Park Orbit code (601-610 for iPECS-100, or 601 for
iPECS-300 & 600).
26