LSIS SV-IS7 User Manual

Using the Keypad
86
No
Function
Display
Description
J
Jog frequency command
R
Internal 485 frequency command
1-9 A-F
Multi-step frequency command
4
Multi-function
key settings
JOG key
Used to switch to Keypad JOG mode
Local/Remote
Used to select local or remote operation
User Group
Select key
Used to register parameters as a user group in
Parameter mode or delete parameters in the user
group.
5
Inverter
operating
status
STP
Motor stopped
FWD
Operating in the forward direction
REV
Operating in the reverse direction
DC
DC output
WAN
Warning
STL
Stalling
SPS
Speed Search
OSS
Software over current controlled
OSH
Hardware over current controlled
TUN
Auto tuning
*OSS / OSH may cause overcurrent when the load is too large or when the
acceleration/deceleration time is short. The inverter monitors the output current so that an
overcurrent trip does not occur and also performs overcurrent suppression.
At this time, the output frequency is automatically changed to reduce the output current or
the inverter output is temporarily cut off to prevent overcurrent.

LSIS SV-IS7 Specifications

General

Brand	LSIS
Model	SV-IS7
Category	Inverter
Language	English