Mack ASET AC - Dipstick Tube Removal; Oil Cooler and Oil Filter Mounting Bracket Assembly Removal [215 DW, 219 EP]

MAINTENANCE
Page 133
113
Figure 113 — Apply Loctite
®
271 to Spindle Threads
5. Assemble the new spindle to the oil filter
mounting adapter. Use an accurately
calibrated torque wrench with a 5/8″ crow’s
foot to tighten the spindle to 26 lb-ft
(35 N폷m).
114
Figure 114 — Tightening Spindle
6. Install a new O-ring on the filter housing
base (Figure 115). The O-ring should be
installed dry, non-lubricated.
115
Figure 115 — O-Ring Installation
7. Install a new ULTRA PLUS rotor over the
spindle.
8. Install the cover assembly and tighten the
retaining nut to 19 lb-ft (26 N폷m).
9. After one hour, start the engine and check
for leaks.
Allow the Loctite
®
to cure for a minimum of one
hour before starting and running the engine.
1. O-Ring 2. Filter Base
5-111.bk Page 133 Monday, July 10, 2006 2:26 PM