REPAIR INSTRUCTIONS, PART 1
Page 259
286
Figure 286 — Inlet/Exhaust Valve Head Height/Depth Measurement
If the dimensions are not within specification,
machine the valve seat insert and/or valve face
as necessary. Refer back to the “Valve Seat
Insert Replacement” procedure in this section.
1. Inlet Protrusion Above Deck: 0.047 inch
+0.009/−0.007 inch (1.194 +0.229/−0.178 mm)
2. Inlet Valve
3. Exhaust Valve
4. Exhaust Valve Depth Below Deck: 0.021 inch
+0.009/−0.007 inch (0.553 +0.229/−0.178 mm)
5-111.bk Page 259 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
