CYLINDER BLOCK/CRANKCASE
Page 4B-3990-857046R1 NOVEMBER 2001
7. Reconnect the power trim harness wires.
8. Install spark plugs
9. Install bottom cowl. Tighten screws to specified torque.
c
a
b
a-Screw (6)-M6 x 30
b-Lower Cowl
c-Screw-M6 x 60
Bottom Cowl Screw Torque
60 lb-in. (7 Nm)
10. Connect battery cables to battery terminals (red goes to positive terminal).
11. Check engine oil level.
Tiller Handle Models
1. Refer to section 7B for installation of throttle cables, shift rod and tiller handle wiring.
To Next Page
Loading...
