MANUAL STARTER
Page 8-6 90-857046R1 NOVEMBER 2001
Manual Starter Disassembly
WARNING
When disassembling and reassembling rewind starter, SAFETY GLASSES must be
worn in case rewind spring uncoils out of the housing.
1. Remove cam retainer.
2. Remove cam, interlock lever, and springs.
a
b
c
d
e
f
a-Screw (3) 10-16x.625 (1/4 in. Hex)
b-Cam Retainer
c-Cam
d-Spring (Cam)
e-Interlock Lever
f-Spring (Interlock Lever)
3. Pull starter rope handle out from rewind starter about 1 ft. (30.5cm) and tie an overhand
knot at this point to prevent rope from being pulled back into rewind starter.
4. Untie the knot in the starter rope handle. Untie knot in starter rope (from previous step).
Release starter rope and allow rewind spring to unwind.
b
a
a-Knot in Starter Rope
b-Knot in Starter Rope Handle