Mercury 40 FourStroke - Oil Pump Installation

POWER TRIM
Page 5B-46 90-857046R1 NOVEMBER 2001
Oil Pump Installation
1. Install spring, ball, lubricated o-ring and plastic seat to manifold.
2. Check to see that o-rings are placed on bottom of pump.
3. Install filter and filter seal under pump. Install pump onto manifold. Tighten screws to
specified torque.
b
a
a-Screw (3)
b-Suction Seat Assembly
Screw Torque
70 lb-ft (8.0 Nm)