BIGFOOT GEAR HOUSING
Page 6B-12 90-857046R1 NOVEMBER 2001
Removal
WARNING
To prevent accidental engine starting, remove (and isolate) spark plug leads from
spark plugs before removing gear housing.
IMPORTANT: 90 hp (4-Stroke) models, when removing or installing gearcase care-
fully guide driveshaft through drive shaft bushing to avoid scoring bushing surface.
1. Remove (and isolate) spark plug leads from spark plugs.
2. Shift engine into forward gear.
3. Tilt engine to full “Up” position.
4. Remove 4 fasteners.
5. Remove locknut and washer.
6. Remove gear housing.
53992
b
a
a- Fasteners (2 Each Side)
b- Locknut and Washer
To Next Page
Loading...
