BIGFOOT GEAR HOUSING
90-857046R1 NOVEMBER 2001 Page 6B-47
6. Assemble Pinion Gear Locating Tool (91-12349A2) as shown. Do not tighten collar re-
taining screw at this time. Install gauging block with numbers away from split collar.
a
b
c
d
e
f
c
a- Arbor
b- Gauging Block
c- Screw (2)
d- Split Collar
e- Collar Retaining Screw
f- Snap Ring
7. Insert tool into forward gear assembly. Position gauging block under pinion gear as
shown.
22067
a
a- Gauging Block
8. Remove tool, taking care not to change gauging block position, and tighten collar retain-
ing bolt.
9. Insert tool into forward gear assembly. Position proper numbered flat (from chart) of
gauging block under pinion gear.
MODEL GEAR RATIO (PINION
GEAR TEETH/REVERSE
GEAR TEETH)
USE
FLAT NO.
LOCATING
DISC NO.
40/50 Bigfoot (4-stroke, 747cc/935cc)
2.31:1 (13/30) 8 3
40/50/60 Bigfoot (4-stroke, 995cc)
2.31:1 (13/30) 8 3
75/90/115EFI (4-stroke) 2.07:1 (14/29)
2 3
60 Bigfoot/60 Seapro
60 Marathon
2.31:1 (13/30) 8 3
75-thru-90
(3 Cylinder)
2.31:1 (13/30) 8 3
100/115/125
(4 Cylinder)
2.07:1 (14/29) 2 3
To Next Page
Loading...
