EasyManua.ls Logo

Mercury 40 FourStroke - Page 6

Mercury 40 FourStroke
584 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SPECIFICATIONS
Page 1A-2 90-857046R1 NOVEMBER 2001
IGNITION
SYSTEM
Readings taken @
68°F (20°C).
Type
Spark Plug:
Type
Gap
Hex Size
Torque
Hole Size
Firing Order
Ignition Timing:
@ Idle (800 rpm)
@ WOT (6000 rpm)
Charge Coil Resistance
Crank Position Sensor Resistance
Ignition Coil Resistance:
Primary
Secondary (W/o Boots)
ECM Engine Speed Limiter
Soft Reduction (Retards Timing)
Spark Cut-Out Reduction (Percent-
ages of ignition spark are Cut-Out)
ECM Overheat/Low Oil Pressure
Speed Control
Engine Temperature Sensor
Capacitor Discharge Ignition
NGK DPR6EA-9
0.035 in. (0.9 mm)
18 mm
150 lb-in. (17 Nm)
12mm
1-2-3
10° A.T.D.C
28° B.T.D.C
660 - 710 (GRN/WHT - WHT/GRN)
300 - 350 (RED - WHT)
0.08 - 0.7 (BLK - BLK/WHT)
3.5 - 4.7 k (BLK - High Tension)
6200 rpm
6250 rpm
Approximately 2000 rpm
See Graph Section 2A-Ignition
CHARGING
SYSTEM
Readings taken @
68°F (20°C).
Alternator Type:
6 Amp Manual Lighting Coil Output
Lighting Coil Resistance
15 Amp. Electric Alternator Output
Battery Charging Coil Resistance
Power Bobbin Resistance
(For Electrothermal Valve)
Quicksilver Tachometer Setting
Single Phase (12 Pole)
6 Amps
0.9 - 1.1 Ohms (YEL-YEL)
12.6 V-15 Amps. (185 Watts)
(Rectified/Regulated)
0.22 - 0.24 Ohms (YEL-YEL)
6.7-7.1 Ohms (YEL/BLK-YEL/BLK)
“6P” or “4”
STARTING
SYSTEM
Manual Start
Electric Start:
Starter Type
Output
Ampere Draw Under:
(Load)
(No Load)
Recoil Start
Bendix
1.1 kW
174.0 Amps
23.7 Amps
BATTERY
Battery Rating
Minimum Requirement
For operation below 32° F (0° C)
Ampere-Hours (Ah) Minimum
For operation above 32° F (0° C)
For operation below 32° F (0° C)
465 Marine Cranking Amps (MCA)
or 350 Cold Cranking Amps (CCA)
1000 Marine Cranking Amps (MCA) or
775 Cold Cranking Amps (CCA)
70
105
IMPORTANT: Use resistive spark plugs only.

Table of Contents

Related product manuals