Moog Animatics SmartMotor™ Developer's Guide,Rev. L
Page 807 of 909
CAUTION: The Z command should not be used at or near the top of a user
program. Doing so may cause a continuous and repetitive resetting of the CPU
and lock out the motor.
NOTE: If you get locked out and are unable to communicate with the SmartMotor,
you may be able to recover communications using the SMI software's
Communication Lockup Wizard. For more details, see Communication Lockup
Wizard on page 30.
EXAMPLE:
Z 'Warning issuing this command will cause CPU reset immediately
RELATED COMMANDS:
RUN Run Program (see page 682)
RUN? Halt Program Execution Until RUN Received (see page 684)
Part 2: Commands: Z
To Next Page
Loading...
