2-21
Syntax (Global Config)
service [advanced-vty|dhcp|password-encryption (secret)2 LINE|pm(restart)|
prompt(crash-info)|radius (restart)|set (command-history <10-300>|
reboot-history <10-100>|upgrade-history <10-100>)|
show (cli)|terminal-length <0-512>]
Parameters(Global Config)
wireless
[ap-history|
buffer-counters|
clear-ap-log <1-256>|
dump-core |
idle-radio-send-multicast|
legacy-load-balance|
map-radios <1-127>|
rate-scale|
request-ap-log <1-256>|
save-ap-log|
snmp-trap-throttle]
Wireless parameters.
• ap-history – Access port history.
• buffer-counters – Allocation counts for various buffers.
• clear-ap-log – Clears ap logs.
• dump-core – Creates a core file of the ccsrvr process.
• idle-radio-send-multicast – Forward multicast packets to radios without
associated mobile units.
• legacy-load-balance – Invoke legacy load balance algorithm with
RFS7000 1.0/1.1
• map-radios – Sets radio-to-cpu mapping constant.
• rate-scale – Enables wireless rate scaling (default).
• request-ap-log – Requests access port log.
• save-ap-log – Saves a debug/error log sent by the access port.
• snmp-trap-throttle – Limit the number of SNMP traps generated from the
wireless module.
advanced-vty
Enables advanced mode vty interface.
dhcp
Enables the DHCP server service.
password-encryption
(secret)2 LINE
Encrypts passwords.
• secret (2) – Encrypts passwords with secret phrase, using SHA256-
AES256 encryption.
• LINE – Enter a passphrase for encryption.
pm
(sys-restart)
Process Monitor.
• sys-restart – Enables PMLite to reboot the system when a deamon has
been restarted maximum number of times. The default value is to reboot
the system.
This enables the process monitor to restart the system when a process
fails.
Note Use the [no] service pm sys-restart command to
disallow a rebbot of the system eve nafter a process has been
restarted to its maximum number of times. This is useful for
debugging purpose.
To Next Page
Loading...
Need help?
General
