20-11
20.1.8 broadcast-tx-speed
Wireless Configuration Commands
Use this command to configure the rate broadcast and multicast traffic transmitted between the switch and
mobile units.
Syntax
broadcast-tx-speed(range|throughput)
Parameters
Example
RFS7000(config-wireless)#broadcast-tx-speed range
RFS7000(config-wireless)#
RFS7000(config-wireless)#broadcast-tx-speed throughput
RFS7000(config-wireless)#
range Uses the lowest basic rate. Provides the maximum range.
throughput Uses the highest basic rate. Provides the maximum throughput (default).
To Next Page
Loading...
