Overview
20-32
20.1.26 no
Wireless Configuration Commands
Use this command to negate a command or set its defaults.
Syntax
no(adopt-unconf-radio|adoption-pref-id|ap-detection|broadcast-tx-speed|country-
code|dhcp-sniff-state|dot11-shared-key-auth|fix-windows-dhcp|ids|mac-auth-
local|manual-wlan-mapping|mobile-unit|mobility|oversized-frames|proxy-arp|qos-
mapping|radio|self-heal|sensor|service|smart-scan-channels|wlan)
Parameters
Refer to Table 20.1 on page 20-1 for the parameters negated using the no command.
Example
RFS7000(config-wireless)#no mobility enable
RFS7000(config-wireless)#
To Next Page
Loading...
