20-31
20.1.25 multicast-throttle-watermarks
Wireless Configuration Commands
Use this command to configure watermarks for handling bursts of broadcast/multicast frames.
Syntax
multicast-throttle-watermarks (low)<0-100> (high) <0-100>
Parameters
Example
RFS7000(config-wireless)#multicast-throttle-watermarks low 10 high 20
RFS7000(config-wireless)#
low <0-100> Configures the low water-mark. If the percentage of free packets in the system
is lower than this threshold, the incoming frame will be dropped.
high <0-100> Configure the high water-mark. If the percentage of free packets in the system
is between the low water-mark and this value, the packet is subjected to a
random-early-drop. If free packets are greater than this value, the packet is
processed.
To Next Page
Loading...
