Overview
20-36
antenna-mode
<diversity|primary|secondar
y>
Antenna diversity mode. Select from the following options:
• diversity–Full diversity (both antennas).
• primary–Primary antenna only.
• secondary–Secondary antenna only.
NOTE Before executing this command, ensure the radio is present and is
an AP300.
base-bridge
(enable|maxclients
<1-12>)
Base bridge settings.
• enable – Allows the given radio to act as a base bridge and accept
connections from client bridges.
• max-clients <1-12> – Configure a base-bridge. Enter maximum client
bridges allowed.
beacon-interval<50-200>
Beacon interval in K-uSec.
bss (<1-4>|add-wlans|auto)
WLAN
Maps wireless LANs to radio BSSID’s.
• <1-4> –The BSS where a wireless LAN is mapped.
• add-wlans – Adds new wlans to existing radios.
• auto – Automatic assignment of BSS. If the user selects wireless lans d
the system assigns them to a BSS automatically.
• WLAN – A list (1,3,7) or range (3-7) of WLAN indices. When a BSS is
specified, the first WLAN is used as the primary WLAN. When the auto
option is used, the system automatically assigns the first four WLANs
as primaries on their respective BSS’s.
channel-power
(indoor|outdoor)
(<1-2000>|acs|random)
<4-20>
Location, channel and transmit power level.
• indoor – Indoor location.
• outdoor – Outdoor location.
• <1-2000> – Channel number.
• acs – Auto channel selection (radio scans for the least congested
channel at startup or reconfiguration).
• random – Random channel selection.
• <4-20> – Power in dBm.
client-bridge [bridge-select-
mode|enable|mesh-
timeout|ssid]
Client bridge setting.
• bridge-select-mode [auto|manual] – Client Base bridge selection mode.
• auto
– Automatically select base bridge.
• manual – Manually select base.
• enable – Enables client-bridge functionality on radio.
• mesh-timeout <2-200> – Client bridge link timeout.
• ssid – ESSID of the WLAN to be used.
To Next Page
Loading...
Need help?
General
