5 - 234 WiNG 5.6 Access Point System Reference Guide
7. Review the following parameters unique to each Virtual Interface configuration to determine whether a parameter override
is warranted:
Once the configurations of existing Virtual Interfaces have been reviewed, determine whether a new interface requires
creation, or an existing Virtual Interface requires edit (override) or deletion.
8. Select Add to define a new Virtual Interface configuration, Edit to modify or override the configuration of an existing Virtual
Interface or Delete to permanently remove a selected Virtual Interface.
Figure 5-151 Device Overrides - Virtual Interfaces - Basic Configuration screen
Name Displays the name of each listed Virtual Interface assigned when it was created. The
name is from 1 - 4094, and cannot be modified as part of a Virtual Interface edit.
Type Displays the type of Virtual Interface for each listed interface.
Description Displays the description defined for the Virtual Interface when it was either initially
created or edited.
Admin Status A green check mark defines the listed Virtual Interface configuration as active and
enabled with its supported profile. A red “X” defines the Virtual Interface as currently
disabled. The interface status can be modified when a new Virtual Interface is created or
an existing one modified.
VLAN Displays the numerical VLAN ID associated with each listed interface.
IP Address Defines whether DHCP was used to obtain the primary IP address used by the Virtual
Interface configuration.
To Next Page
Loading...
