EasyManua.ls Logo

MR ETOS IM - Page 408

MR ETOS IM
412 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
List of key words
Maschinenfabrik Reinhausen GmbH 2019408 5163667/06 ENETOS
®
IM
P
Parallel operation 137, 142
CAN bus 143
Circulating reactive current 139
Information 305
Parallel operation error mes-
sage 147
Power factor 140
Tap synchronization 138
Parallel operation method 143
Parity 221, 261, 265, 272
Password 297
Performing standardization 215
Phase angle correction 118
power factor 140
Power flow
Negative 155
Power flow monitoring 155
Power monitoring 154
Protective device status 190
Q
QS3 30
Query rate 221
Quick search 45
R
Rated power of the transformer
247
Ratio of the evaluated power loss
248
Recorder 169
Average value interval 173
Rectifying faults 333
Reference time263, 266, 269, 277
Regulation 97
Regulation mode 134
Remote behavior 96
Repeat unsolicited messages in-
definitely 276
RES bit test 262
Reversal of power flow 155
RFC 3164 290
RFC 5424 290
Rogers 208
Rotary switch 77
S
SCADA 256
Second time server 293
Select desired value 98, 99
Send delay time 221
Sensor bus
Link functions 223
Serial interface 259, 264, 271, 274
setting of the desired value
analog 99
Step-by-step 100
Single character confirmation 262
SNTP 292, 293
SNTP time server 293
SNTP time server 2 294
Software
Information 305
SSL/TLS encryption 94
State of the bushings 218
Stop bits 221, 262, 265, 272
Subnet mask 257, 267, 273
General 94
SW 3-3 35
Configuration 309
Switching direction 137
Switching point 193
Switching pulse pause 135
Switching pulse time 135
Switch-on delay 194
Synchronization interval 294
Syslog 290
T
Tap difference
Follower 146
Tap position
Changing designation 178
Tap position monitoring 157
Tap synchronization 138
Tap-change operation statistics
179
TAPCON® 2xx retrofit 147
TAPCON® Dynamic Setpoint Con-
trol 101, 104
Target tap position 168
Target-tap-position operation 168
TCP connections 271
TCP Keepalive 271
TCP port 268, 270, 274
Temperature
Curve 174
Monitoring 162
Time 90, 295
Time response T1 113
Time server address 293
Time shift 294
Time synchronization 292
Activate 293
Reference time 263, 266, 269,
277
Time zone 294
TLS version 95
TPLE 316
Transformer
Overview 39
Transformer data 116, 211
Primary current 117
Primary voltage 116
Secondary current 117
Secondary voltage 116
Transmission procedure 260
Tx statistics 163

Table of Contents

Related product manuals