Electra Elite Issue 6
Features and Specifications Manual C - 47
General:
Features like Code restriction, or forced account codes that are
enabled for the Call Forward – Off-Premise extension apply to any
call that follows Call forward – Off-Premise.
The Feature key LED flashes red when Call Forward – Off-Premise
(All Calls) is set from a Multiline Terminal.
The ACD/UCD overflow destination station can be set to Call
Forward – Off-Premise.
The Access Codes for Call Forward set and cancel can be
programmed on Feature Access keys or One-Touch keys. Press the
key during the conversation with an internal or outside party to place
the call on hold and dial the Access Code.
When a Call Forward ON/OFF key (All Call or Busy/No Answer) is
programmed on the line key, set/cancel toggles. The Trunk Access
Code and destination outside number must be dialed after pressing
this key when setting Call Forward – Off-Premise.
Incoming calls from a voice mail system follow the Call
Forward – Off-Premise setting.
The Call Arrival (CAR) key number can be set for Call
Forward – Off-Premise. System Software S4000 or higher is
required.
The Speed Dial number cannot be set as the destination forward
number.
When the system is installed in the Key Function (KF) mode, a
Specified Line Seizure Access Code must be used when setting Call
Forward – Off-Premise.
The following incoming calls can be forwarded:
• CO/PBX Transfer Call
• Ordinary Incoming Internal Call
• Direct Inward Termination (DIT)
• Assigned Night Answer (ANA)
• Direct Inward Dialing (DID)
• Tie Line (TIE)
• Automated Attendant (AA)
When the outside party, where the call is forwarded, is busy or does
not answer, the call is terminated when the calling party hangs up.
To Next Page
Loading...