Electra Elite Issue 6
Features and Specifications Manual D - 33
1. Press
T
.
2. Dial
HA
to set or
HB
to cancel.
3. Enter the CO/PBX line number (
KK
~
FD
).
KK
= All Trunks
4. Press
T
.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] Function No. 251 to assign a DISA Password from any
station. Up to 10 digits are allowed.
Use Memory Block 1-9-00 (DISA ID Code Assignment) to specify A
DISA ID Code as 2, 3, or 4-digits that can correspond to a station
number.
Use Memory Block 1-9-02 (DISA Password Effect/Invalid Selection)
to assign DISA password as valid or designate it invalid to allow
caller to use DISA without a password.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the VRS(4)-U10 ETU.
Restrictions:
DTMF signaling is required from the outside caller.
Internal calls must be made before the DISA Access Code is
entered.
General:
When the DISA feature is activated, the incoming outside caller
hears a special tone when DISA trunks are called. These trunks can
still be used for outgoing calls.
A maximum 64 trunks for DISA can be installed in the Electra Elite
192 system, or 16 trunks in the Electra Elite 48 system. Each trunk
can be programmed for Day Mode or Night Mode.
Code Restriction depends on setting a station that has a DISA ID
number.
Outgoing calls using DISA cannot access LCR.
To set/cancel a CO/PBX line used for DISA at the Attendant
Position:
To Next Page
Loading...