NEC SL1000 - Page 124

Item
No.
Item Input Data Default
Related Pro-
gram
Note
07 DP to DTMF Conversion Op-
tions
Determine how a user can con-
vert a Dial Pulse (DP) call to a
DTMF call. For each trunk, set
the type of DP to DTMF conver-
sion required. There are three
conversion options: Automatic
(0), Automatic and Manual (1),
or Manual (2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension
user waits more than 10 sec-
onds before dialing the next
digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension
user waits more than 10 sec-
onds before dialing the next
digit. In addition, the user can
dial # to switch a DP trunk to
DTMF dialing.
Manual:
Users can dial # to switch a DP
trunk to DTMF dialing.
0 = Automatic
1 = Automatic and Manual
2 = Manual
2 21-01-03
08 Answering Condition 0 = Polarity Reversing
(Polarity)
1 = Polarity Reversing or
Timer (Int Digit)
1 21-01-03
09 Busy Tone Detection 0 = Disable (No)
1 = Enable (Yes)
0
10 Caller ID
Enable or disable a trunk ability
to receive Caller ID information.
0=No
1=Yes
0
11 Next Trunk in Rotary if No
Dial Tone
Use this option to enable/
disable the system ability to
skip over a trunk if dial tone is
not detected. This option per-
tains to calls placed using
Speed Dial, ARS, Last Number
Redial or Save Number dialed.
It does not pertain to line key or
Direct Trunk Access calls.
0 = Disable (No)
1 = Enable (Yes)
0
12 Detect Network Disconnect
Signal
0 = Disable (No)
1 = Enable (Yes)
0
13 Trunk-to-Trunk Limitation 0 = Disable (No)
1 = Enable (Yes)
0
16 Caller ID Type 0 = FSK
1 = DTMF
0
18 Busy Tone Detection on Talk-
ing
0=Disable
1 = Enable
0
19 Busy Tone Detection Fre-
quency
1 ~ 255 1 14-02-18
20 Busy Tone Detection Interval 0 ~ 64800 (x 100 ms) 0 14-02-18
Conditions
None
ISSUE 1.0SL1000/SL1100
Program
14
Program 14 : Trunk, Basic Setup2-102