NEC SL1000 - Account Code Setup

Program 35 : SMDR Account Code Setup
35-05 : Account Code Setup
Level
IN
Description
Use Program 35-05 : Account Code Setup to set various Account Code options for an extension
Class of Service. Assign a Class of Service to extensions in Program 20-06.
Input Data
Class of Service Number 01 ~ 15
Item No. Item Input Data Default
01 Account Code Mode
Use this option to select the Account
Code Mode (0 ~ 3).
0 = Account Codes Disabled (None)
1 = Account Codes optional
2 = Account Codes Required but not verified (No verify)
3 = Account Codes Required and Verified (Verify)
0
02 Forced Account Code Toll Call
Setup
Use this option enable Account
Codes for all calls or just toll calls (for
mode 2 or 3 in Item 01 above).
0 = Account Codes for toll and local calls (All)
1 = Account Codes just for toll calls (STD)
0
03 Account Codes for Incoming Calls
Use this option to allow users to enter
Account Codes for incoming calls. If
disabled, any codes entered dial out
on the connected trunk.
0 = Account Codes for incoming calls disabled (No)
1 = Account Codes for incoming calls enabled (Yes)
0
04 Hiding Account Codes
Use this option to either hide or show
the Account codes on a telephone
display.
0 = Account Codes displayed
1 = Account Codes not displayed
0
Conditions
None
Feature Cross Reference
• Account Code Forced/Verified/Unverified
ISSUE 1.0 SL1000/SL1100
Program
35
Programming Manual 2-349