NEC SL1000 - Single Line Telephone Basic Data Setup

Program 15 : Extension, Basic Setup
15-03 : Single Line Telephone Basic Data Setup
Level
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various single line tele-
phone options.
Input Data
Extension Number Maximum four digits (SL1000)
Maximum eight digits (SL1100)
Item
No.
Item Input Data Default
Related Pro-
gram
Note
01 SLT Signaling Type
Use this option to tell the system the
type of dialing the connected tele-
phone uses.
For Analog Wireless telephones to
function correctly, this must be set to
0 (dial pulse). If this option is set for
DTMF, after an outside call is
placed, the system cannot dial any
additional digits.
This program change is automati-
cally performed when the Analog
Wireless telephone is registered.
When upgrading software from prior
versions, the previous default of 1 is
saved from the prior database so
this option must be changed manu-
ally.
0=DP
1 = DTMF
1 15-03-03
45-01-01
03 Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
0 15-03-01
45-01-01
04 Flashing
Enables/disables Flash for single
line telephones.
0=No
1=Yes
1
05 Trunk Polarity Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
0=Off
1=On
0
06 Extension Polarity Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
0=Disable(Off)
1 = Enable (On)
0
07 Enabled On-Hook When Holding
(SLT)
0=No
1=Yes
1 11-12-45
08 Answer On-Hook when Holding
(SLT)
0 = Disable (No)
1 = Yes (Enable)
1 11-12-46
ISSUE 1.0SL1000/SL1100
Program
15
Program 15 : Extension, Basic Setup2-124