NEC SL1000 - Dial Analysis Table for ARS;F-Route Access

Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
Level
IN
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction Table
for selecting ARS/F-Route.
Input Data
Dial Analysis Table Number 001 ~ 120
Item No. Item Input Data Default
01 Dial
Set the number of digits to be analyzed by the system for ARS
routing.
Up to four digits (SL1000)
Up to eight digits (SL1100)
(Use line key 1 for a Don’t
Care digit, @)
No setting
02 Service Type
• Service Type 1 (Extension Number)
The number goes to an extension after deleting the front
digit(s).
Additional Data
Assign the digit(s) to be deleted on top of the number for
extension number usage. At least one digit must be de-
leted.
• Service Type 2 (ARS/F-Route)
The number is controlled by ARS/F-Route table.
Additional Data:
If the ARS/F-Route Time Schedule is not used, assign
the ARS/F-Route table number for Program 44-05.
If the ARS/F-Route Time Schedule is used, assign the
ARS/F-Route selection number for Program 44-04.
• Service Type 3 (Dial Extension Analyze Table)
The total length of the number exceeds more than 8 dig-
its.
Additional Data:
Assign the Dial Extension Analysis Table number to be
used in Program 44-03.
0 = No setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
0
03 Additional Data
For the Service Type selected in 44-02-02, enter the additional
data required.
• 1:DeleteDigit=0~255
(255 = Delete All Digits)
• 2 : [Program 44-01 : 0]
ARS/F-Route Table Number=0~100(0=Nosetting)
Refer to Program 44-05.
[Program 44-01 : 1]
ARS/F-Route Select Table Number=0~100(0=Noset-
ting)
Refer to Program 44-04.
• 3 : Dial Extension Analyze Table Number=0~4(0=No
setting)
Refer to Program 44-03.
1=DeleteDigit=0~255
(255 = Delete All Digits)
2=0~100(0=Noset-
ting)
3 = Dial Extension Analyze
Table Number=0~4(0=
No setting)
0
04 Dial Tone Simulation
If enabled, this option sends dial tone to the calling party after
the routing is determined. This may be required if the central
office at the destination does not send dial tone.
0=Off
1=On
0
Conditions
None
ISSUE 1.0SL1000/SL1100
Program
44
Program 44 : ARS/F-Route Setup2-364