NEC SL1000 - Incoming Virtual Extension Ring Tone Setup

Program 15 : Extension, Basic Setup
15-08 : Incoming Virtual Extension Ring Tone Setup
Level
IN
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a ring tone range (0 ~
4) to incoming virtual extensions assigned to a Virtual Extension key (Program 15-07). If you enable
ringing for the key in Program 15-09, the key rings with the tone you set in this program. Also see Pro-
gram 22-03. The chart below shows the available tones. There are 126 (SL1000) 096 (SL1100) avail-
able extension ports.
Input Data
Extension Number Maximum four digits (SL1000)
Maximum eight digits (SL1100)
Item No. Incoming Ring Pattern Default Description
01 0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Ring Tone Extension
5 = Tone pattern 5 (SL1000)
6 = Tone pattern 6 (SL1000)
7 = Tone pattern 7 (SL1000)
0 = Tone Pattern 1 When an extension or a virtual ex-
tension is assigned to the function
key on the key telephone, select the
ring tone when receiving a call on
that key.
Program 15-08 - Incoming Signal Frequency Patterns
Incoming Signal
Frequency Pattern Type Frequency 1 Frequency 2 Modulation
Pattern 1 High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
16 Hz
16 Hz
16 Hz
Pattern 2 High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
8Hz
8Hz
8Hz
Pattern 3 High
Middle
Low
2000 Hz
1400 Hz
1100 Hz
760 Hz
660 Hz
540 Hz
16 Hz
16 Hz
16 Hz
Pattern 4 High
Middle
Low
2000 Hz
1400 Hz
1100 Hz
760 Hz
660 Hz
540 Hz
8Hz
8Hz
8Hz
Internal Incoming Sig-
nal Frequency
High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
8Hz
8Hz
8Hz
Conditions
None
Feature Cross Reference
None
ISSUE 1.0 SL1000/SL1100
Program
15
Programming Manual 2-139